wanweipedia

ISO 1745

ISO 1745:1975 Information processing – Basic mode control procedures for data communication systems is an early ISO standard defining a Telex-oriented communications protocol that used the non-printable ASCII transmission control characters SOH (Start of Heading), STX (Start of Text), ETX (End of Text), EOT (End of Transmission), ENQ (Enquiry), ACK (Acknowledge), DLE (Data Link Escape), NAK (Negative Acknowledge), SYN (Synchronous Idle), and ETB (End of Transmission Block).

It also defines a serial data format, consisting of a start bit, 7 bit ASCII (least significant bit first), a parity bit (even for asynchronous networks, odd for synchronous networks), and a stop bit.

The text of ISO 1745:1975 is not currently freely available,[1] but the corresponding ECMA version is.[2] The protocol it defines seems to now be little used.[citation needed]

References

  1. ^ "ISO 1745: Scope and field of application".
  2. ^ "Basic Mode Control Procedures for Data Communication Systems using the ECMA 7-Bit Code, 2nd Edition" (PDF). 1973.



This page was last updated at 2021-05-09 00:05, update this pageView original page

All information on this site, including but not limited to text, pictures, etc., are reproduced on Wikipedia (wikipedia.org), following the . Creative Commons Attribution-ShareAlike License


Top

If the math, chemistry, physics and other formulas on this page are not displayed correctly, please useFirefox or Safari